Hello,

I think that this problem is probably on the iSeries.  It sounds like
you're running a program that uses a print file or override where you
are leaving the form type blank.

I could be mistaken, but I don't think lp5250d is involved with the form
type at all.   I think this is handled by OS/400 before it even sends any
data to lp5250d.

Perhaps a CL program (or similar) was changed to add an OVRPRTF command
to your new lp5250d printer, and a mistake was made on the OVRPRTF
command?   Or maybe the print file itself was changed, and the form type
was accidentally erased?

If you run this same report to a SNA/Twinax attached printer, do you
have different results?


On Tue, 31 Dec 2002, GOMES Rui Pedro wrote:

> Hello everyone!
>
> I have set up lp5250d in linux correctectely and it prints fine, but with
> the exception of one small detail: everytime I release a print job on the
> as400 to the printer (env.DEVNAME = CONTLIN), it gives a msg saying that I
> should "Put the *STD paper type in the printer CONTLIN." and that the paper
> type was left blank. I always disregard the message, and press the G option,
> and the printing turns out great.
>

_______________________________________________
This is the Linux 5250 Development Project (LINUX5250) mailing list
To post a message email: [EMAIL PROTECTED]
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/cgi-bin/listinfo/linux5250
or email: [EMAIL PROTECTED]
Before posting, please take a moment to review the archives
at http://archive.midrange.com/linux5250.

Reply via email to