On 13-08-26 08:38 AM, Eric Brackenbury wrote:
For those who may be interested :-)
Eric B
http://www.gizmag.com/opendesk-open-source-diy-furniture/28813/?utm_source=Gizmag+Subscribers&utm_campaign=4d74288da2-UA-2235360-4&utm_medium=email&utm_term=0_65b67362bd-4d74288da2-91236253
I will agree with the comment on the site, that the design shown does
not pay any attention to efficient use of material. Of course part of
the problem is the old try to make something out of one piece of plywood
problem. cutting different parts out of different sheets would likly
allow more room for economical design.
--
Charles MacDonald Stittsville Ontario
[email protected] Just Beyond the Fringe
http://Charles.MacDonald.org/tubes
No Microsoft Products were used in sending this e-mail.
_______________________________________________
Linux mailing list
[email protected]
http://oclug.on.ca/mailman/listinfo/linux
