Eric W. Biederman wrote: > For even more fun I have had a hardware glitch that caused the the > memory size to be set to 0 after initializing it, properly. The copy > succeeded when I had no ram at all. Of course I couldn't execute the > LinuxBIOS code. > > Have you enabled the serial port?
I have enabled the serial port, but no console message so far. Perhaps, my bigger challenge is to get access to documentation for this board. It's manufactured by Portwell (NAD-2050), but there is very data that is available on their site or from the live techsupport contact. > There is a file ramtest.inc that you can included that will do a basic > sanity check on the ram to see if is working. Usually that is a help > when brining up a new port. I haved tried including ramtest.inc, but without serial port output, it's difficult to tell. BTW: I'm attaching my lspci output and config file for reference. I'm going to do more due-dilligence on SDRAM initialization before I have more progress to report. -- HT
portwell.pci
Description: Binary data
portwell.config
Description: Binary data
