Hello Andrew, > > I have been fiddling with etherboot 5.0.10 and freebios(v1) from CVS today > > on a EPIA-ME6000 platform. > > ... > > When booting, I merely got garbled output on the serial port. > > I have double checked that the config file reads 115200 and that my > > terminal reads 115200 8N1. (The 115200 is assembly hardcoded in > > the vt82c686 superio code -- does it cope with my different processor > > Have you tried 57600? EPIA-M6000 seems to have problem to use 115200 > under LinuxBIOS unless it is boot from normal bios and then reset the > system. That's why you are getting garbage. > > -Andrew > Just to make sure; where would I need to set the 57600 bitrate? The file I have been looking at is the assembler code file in the vt82c686 directory, which just sets a register with some values I cannot compare with a datasheet (as I haven't found one yet). Or am I looking at the wrong file here: ?
http://cvs.sourceforge.net/cgi-bin/viewcvs.cgi/freebios/freebios/src/superio/via/vt82c686/setup_serial.inc?rev=1.2&content-type=text/vnd.viewcvs-markup Also, I blew up my board (probably ESD problem) during replacing the cooling compounds. :-/ I am waiting for a new one... This _does_ give me an extra (and original) FlashROM part. :-) BTW, does anyone know a source for the STT39F020A Flashes? They're hard to come by here. Regards, Leon. _______________________________________________ Linuxbios mailing list [EMAIL PROTECTED] http://www.clustermatic.org/mailman/listinfo/linuxbios
