Ron, It seems I can not enable XIP_ROM_SIZE and XIP_ROM_BASE. Even I have set them in Options.lb
Regards Yinghai Lu -----邮件原件----- 发件人: YhLu 发送时间: 2003年8月6日 15:17 收件人: YhLu; [EMAIL PROTECTED]; ron minnich 抄送: Stefan Reinauer; [EMAIL PROTECTED] 主题: Re: S2880 Ron, After swap _ROMBASE etc to after ROM_SECTION_SIZE and ROM_SECTION_OFFSET. I can switch to the normal mode. But in fallback mode and normal mode ( after reboot) still got problem. ~ # cmos_util -d # The CMOS Definition table was not found in ram # CMOS definition table was not found in RAM memory # Looking for definitions in cmos.layout file Can not open config file cmos.layout Regards Yinghai Lu -----邮件原件----- 发件人: YhLu 发送时间: 2003年8月6日 11:18 收件人: '[EMAIL PROTECTED]'; ron minnich 抄送: Stefan Reinauer; [EMAIL PROTECTED] 主题: S2880 Eric, It seems the image that built with can not switch to Normal booting. 1. In Fallback mode, after power on I can use cmos_util. 2. after rebooting it is still in Fallback mode,and can not cmos_util, it said can not find option table in the ram. And can not access cmos.layout. When I using old tool, I can switch to normal mode, but need to change boot_option and last_boot from fallback to normal. regards Yinghai Lu _______________________________________________ Linuxbios mailing list [EMAIL PROTECTED] http://www.clustermatic.org/mailman/listinfo/linuxbios