Aagh ! Ignore the following files in the archive, as they are not required:
src/include/cpu/stpc/elite/stpc_conf-notused.h src/cpu/stpc/elite/stpc_framebuffer.inc Ta. -- Peter Fox <[EMAIL PROTECTED]> Aeroflex Test Solutions Principal Design Engineer Stevenage Any opinions expressed above are http://www.aeroflex.com/ not necessarily those of Aeroflex. Tel: + 44 (0) 1438 742200 -----Original Message----- From: Peter Fox [mailto:[EMAIL PROTECTED] Sent: 23 February 2004 15:29 To: Linuxbios Subject: Freebios1 STPC Elite development board changes attached Please find attached my changes to support the STPC Elite processor, and the mainboard/elite build configuration for the STPC Elite development board. These changes are for freebios1. They are mostly copies of the consumer-II stuff by Steve M. Gehlbach, but modified to remove all the graphics stuff, as the Elite has no graphics controller, and to add initialisation for the GP clock etc. I've also put in the bit-bashing SPD code for the Elite, though I don't use it on the development mainboard. I can run Redhat 7.1 fine (serial console only) using filo as the payload. This is using the 20/01/2004 snapshot for other files. -- Peter Fox <[EMAIL PROTECTED]> Aeroflex Test Solutions Principal Design Engineer Stevenage Any opinions expressed above are http://www.aeroflex.com/ not necessarily those of Aeroflex. Tel: + 44 (0) 1438 742200 _______________________________________________ Linuxbios mailing list [EMAIL PROTECTED] http://www.clustermatic.org/mailman/listinfo/linuxbios
