Hi all, here is the output of lspci:
00:00.0 Host bridge: Intel Corp. 440BX/ZX - 82443BX/ZX Host bridge (rev 02) 00:01.0 PCI bridge: Intel Corp. 440BX/ZX - 82443BX/ZX AGP bridge (rev 02) 00:04.0 ISA bridge: Intel Corp. 82371AB PIIX4 ISA (rev 02) 00:04.1 IDE interface: Intel Corp. 82371AB PIIX4 IDE (rev 01) 00:04.2 USB Controller: Intel Corp. 82371AB PIIX4 USB (rev 01) 00:04.3 Bridge: Intel Corp. 82371AB PIIX4 ACPI (rev 02) 00:06.0 SCSI storage controller: Adaptec AHA-2940U2/W / 7890 01:00.0 VGA compatible controller: nVidia Corporation NV15 Bladerunner (GeForce2 Ultra) (rev a4) and the output of lspci -v: 00:00.0 Host bridge: Intel Corp. 440BX/ZX - 82443BX/ZX Host bridge (rev 02) Flags: bus master, medium devsel, latency 64 Memory at e4000000 (32-bit, prefetchable) [size=64M] Capabilities: [a0] AGP version 1.0 00:01.0 PCI bridge: Intel Corp. 440BX/ZX - 82443BX/ZX AGP bridge (rev 02) (prog-if 00 [Normal decode]) Flags: bus master, 66Mhz, medium devsel, latency 64 Bus: primary=00, secondary=01, subordinate=01, sec-latency=64 Memory behind bridge: d6000000-d7dfffff Prefetchable memory behind bridge: d7f00000-e3ffffff 00:04.0 ISA bridge: Intel Corp. 82371AB PIIX4 ISA (rev 02) Flags: bus master, medium devsel, latency 0 00:04.1 IDE interface: Intel Corp. 82371AB PIIX4 IDE (rev 01) (prog-if 80 [Master]) Flags: bus master, medium devsel, latency 32 I/O ports at d800 [size=16] 00:04.2 USB Controller: Intel Corp. 82371AB PIIX4 USB (rev 01) (prog-if 00 [UHCI]) Flags: bus master, medium devsel, latency 32, IRQ 19 I/O ports at d400 [size=32] 00:04.3 Bridge: Intel Corp. 82371AB PIIX4 ACPI (rev 02) Flags: medium devsel, IRQ 9 00:06.0 SCSI storage controller: Adaptec AHA-2940U2/W / 7890 Subsystem: Adaptec 2940U2W SCSI Controller Flags: bus master, medium devsel, latency 32, IRQ 19 BIST result: 00 I/O ports at d000 [disabled] [size=256] Memory at d5800000 (64-bit, non-prefetchable) [size=4K] Expansion ROM at <unassigned> [disabled] [size=128K] Capabilities: [dc] Power Management version 1 01:00.0 VGA compatible controller: nVidia Corporation NV15 Bladerunner (GeForce2 Ultra) (rev a4) (prog-if 00 [VGA]) Subsystem: Elsa AG: Unknown device 0c56 Flags: bus master, 66Mhz, medium devsel, latency 64, IRQ 16 Memory at d6000000 (32-bit, non-prefetchable) [size=16M] Memory at d8000000 (32-bit, prefetchable) [size=128M] Expansion ROM at d7ff0000 [disabled] [size=64K] Capabilities: [60] Power Management version 1 Capabilities: [44] AGP version 2.0 On Wed, Mar 17, 2004 at 09:16:56PM +0100, [EMAIL PROTECTED] wrote: > Hi all, > > want to use an ASUS P2B-DS dual P-III mainboard with a MD2202-D32 DoC > device for LinuxBIOS. In the moment I test it with a 2.6.4 kernel. > This board uses a 440bx chip set. > I hot swapped the BIOS Flash chip and the DoC while the board was powered > on and Linux was running. > When I modprobe nftl and docprobe I get the following messages in > /var/log/messages: > > kernel: NFTL driver: nftlcore.c $Revision: 1.94 $, nftlmount.c > $Revision: 1.34 $ > kernel: Possible DiskOnChip with unknown ChipID FF found at 0xfffc8000 > kernel: Possible DiskOnChip with unknown ChipID FF found at 0xfffca000 > > [...] > > kernel: Possible DiskOnChip with unknown ChipID FF found at 0xfffec000 > kernel: Possible DiskOnChip with unknown ChipID FF found at 0xfffee000 > kernel: No recognized DiskOnChip devices found > > No my question now is how to initialize the 440bx to get the DoC > recognized. > > > Thank you in advance, > Andreas > > _______________________________________________ > Linuxbios mailing list > [EMAIL PROTECTED] > http://www.clustermatic.org/mailman/listinfo/linuxbios _______________________________________________ Linuxbios mailing list [EMAIL PROTECTED] http://www.clustermatic.org/mailman/listinfo/linuxbios
