It's OK. PCI: 04:01.0 bridge ctrl <- 0003 PCI: 04:01.0 cmd <- 146 PCI: 05:04.0 cmd <- 142 PCI: 04:01.1 subsystem <- 10f1/2895 PCI: 04:01.1 cmd <- 146 PCI: 04:02.0 bridge ctrl <- 0003 PCI: 04:02.0 cmd <- 147 PCI: 06:06.0 cmd <- 143 PCI: 06:06.1 cmd <- 143
-----Original Message----- From: YhLu Sent: Thursday, October 21, 2004 12:11 PM To: '[EMAIL PROTECTED]' Cc: LinuxBIOS Subject: RE: Freebios2 recovery progress... I will test that on s2885. I suspect that will need MEM enable too. YH -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Sent: Thursday, October 21, 2004 11:39 AM To: YhLu Cc: LinuxBIOS Subject: Re: Freebios2 recovery progress... YhLu <[EMAIL PROTECTED]> writes: > You can not test that in arima board. Because all device on 8131 is using > ioapic in amd8111. I can't test that it works but I can test that the bits are getting set by running lspci. And that is how I tested. The bus master bit is still getting set. I just move the location. Eric _______________________________________________ Linuxbios mailing list [EMAIL PROTECTED] http://www.clustermatic.org/mailman/listinfo/linuxbios
