Christer wrote:
> takes over. So check that the debug baudrate and
> that the baudrate
> for the rest of LinuxBIOS is the same.
>
Yup Christer, you were right. Thanks. It was because
baud rate in serialio.c was set to 115200. So I set it
back to 38400 all over and it gets to almost the final
step of booting! Yay! I think. :-)
Jumping to boot code at 0x10431c
FILO version 0.4.2 ([EMAIL PROTECTED]) Wed Jan 26 19:38:57
IST 2005
Press <Enter> for default boot, or <Esc> for boot
prompt... timed out
boot: hdc1:/bzImage root=/dev/hdc2 console=tty0
console=ttyS0,38400
hdc: LBA 128MB: TOSHIBA THNCF128MMG
Mounted ext2fs
Loading Linux version ...
Jumping to entry point...
Firmware type: LinuxBIOS
So I think I'm almost there now. I think I must have
made some mistake with either filo or mkelfImage
config because it hangs after the "Jumping to entry
point...". So I'm going to take a look at that next. I
think filo isn't able to read the version info out of
the kernel for some reason. I'm using a 2.6.8.1
bzImage that works on this board when I use grub as my
bootloader. I've got my boot partition using ext2 on
hdc1 and my root partition on hdc2. I converted my
bzImage using mkelfImage like so:
--kernel=./bzImage.in --output=bzImage.elf
--command-line="root=/dev/hdc2 console=tty0
console=ttyS0,38400 ro init=/sbin/init"
So I think my first debug step will be to figure out
why filo could not read the version info from the elf
bzImage.
Thanks again!
__________________________________
Do you Yahoo!?
The all-new My Yahoo! - Get yours free!
http://my.yahoo.com
_______________________________________________
Linuxbios mailing list
Linuxbios@clustermatic.org
http://www.clustermatic.org/mailman/listinfo/linuxbios
