> find_ide_controller: found PCI IDE controller 1106:0571 prog_if=0x8f > find_ide_controller: primary channel: native PCI mode > find_ide_controller: cmd_base=0x0 ctrl_base=0x0 > ide_software_reset: Waiting for ide0 to become ready for reset... ok
I'd say your cmd and ctl base registers should be something else other than 0x00. I would expect a number like 0x1f0. I've never used the EPIA so I don't have any specifics but go look in the section that enables the IDE on your chip set and verify IDE is really getting turned on. Perhaps there is a config setting for the base address thats not getting setup? -- Richard A. Smith _______________________________________________ Linuxbios mailing list Linuxbios@clustermatic.org http://www.clustermatic.org/mailman/listinfo/linuxbios
