I'm using FILO 0.4.2 and have PCI_BRUTE_SCAN=1. I found it to be too brute, so I changed it to only scan buses 0,1,2. No need to scan 256 buses.
FILO finds the IDE controller, but the IDE_BASE0 and IDE_BASE1 in FILO's ide.c point to the wrong place. These are PCI addresses? Does FILO assume 8111's PCI addresses for it's IDE? Steve -----Original Message----- From: Stefan Reinauer [mailto:[EMAIL PROTECTED] Sent: Wednesday, March 02, 2005 2:07 PM To: Kimball, Stephen Cc: linuxbios@clustermatic.org Subject: Re: FILO dependencies * [EMAIL PROTECTED] <[EMAIL PROTECTED]> [050302 19:40]: > > I'm using FILO with nVidia reference board with a CK804. I've got > LinuxBIOS to load FILO and FILO sees the IDE controller but not the > drive. I thought FILO was device independent, but could the IDE > controllers on the CK804 require FILO changes? Thanks. You should be using 0.4.2 and be sure to set PCI_BRUTE_SCAN = 1 You probably end up with filo not looking at anything but bus 0. Common problem on amd64 boards. Stefan _______________________________________________ Linuxbios mailing list Linuxbios@clustermatic.org http://www.clustermatic.org/mailman/listinfo/linuxbios
