An image that I built is timing out while filo is looking for the phase 1 image on a DiskOnModule raw device. The same filo payload works perfectly fine with a build of a previous version of LinuxBIOS (1.1.6.0). The following excerpt is from a filo build with the IDE debug flag set:
boot: hda1:/phase1.epia console=ttyS0, 19200 find_ide_controller: found PCI IDE controller 1106:0571 prog_if=0x8f find_ide_controller: primary channel: native PCI mode find_ide_controller: cmd_base=0x0 ctrl_base=0x0 ide_software_reset: Waiting for ide0 to become ready for reset... ok IDE time out No drive detected on IDE channel 0 Everything else up to this point appears to be pretty normal but there was one line missing that shows up in 1.1.6.0 LB builds: vt8231_init: enabling compatible IDE addresses I don't know how relevant this is, but I'd appreciate any help in finding why LB is no longer detecting any IDE drive. _______________________________________________ Linuxbios mailing list Linuxbios@clustermatic.org http://www.clustermatic.org/mailman/listinfo/linuxbios
