Dear Ollie,
It works !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! See below the output that i get at serial port of super i/o: Please, do same comment about the output. Is the erro pointed below according to the development stage of project or not ? LinuxBIOS-1.1.8.0Fallback Sex Mar 3 09:23:01 BRT 2006 starting... CGLP_SYS_RSTPLL 00000010:02008470 prgramming PLL Reset PLL LinuxBIOS-1.1.8.0Fallback Sex Mar 3 09:23:01 BRT 2006 starting... CGLP_SYS_RSTPLL 00000019:07de0378 reboot from BIOS reset Ram1.00 Ram2.00 Ram3 sdram_enable step 1 sdram_enable step 2 sdram_enable step 3 sdram_enable step 4 sdram_enable step 5 sdram_enable step 6 sdram_enable step 7 sdram_enable step 8 Ram4 Testing DRAM : 00000000-000a0000 DRAM fill: 00000000-000a0000 00000000 00010000 00020000 00030000 00040000 00050000 00060000 00070000 00080000 00090000 000a0000 DRAM filled DRAM verify: 00000000-000a0000 00000000 00010000 00020000 00030000 00040000 00050000 00060000 00070000 00080000 00090000 000a0000 DRAM verified Done. Copying LinuxBIOS to ram. Jumping to LinuxBIOS. LinuxBIOS-1.1.8.0Fallback Sex Mar 3 09:23:01 BRT 2006 booting... clocks_per_usec: 643 Enumerating buses... Finding PCI configuration type. PCI: Sanity check failed pci_check_direct failed Thanks. Jardel. Li-Ta Lo wrote: >>>>Dear Mr. Li-Ta Lo, >>>> >>>> >>>> I've tried, but id didn't see any bytes on serial port 0 of the >>>>CS5535. >>>> What is the hardware description of rumba target ? I'm trying it >>>>on the AMD RDK THINCLIENT based on GEODE GX2. >>>> >>>> >>>> >>>> >>>I think our board is the thinclient RDK with the winbond superio duaght >>>board. Did you get the lastest code? Does it compile? >>> >>> >>> >>> >>My Daught board (LPC Expansion) uses the NSC PC87364, the wich is the >>same WINBOND 87364. I compile successfull the last code, but i was not >>able to see anything on serial port 0 of CS5535. But something is clear >>for me now: if you don't have VSA initialized, you aren't able for using >>serial port of companion chip. As a matter of fact, you are probably >>sending the bytes to port 0 of winbond super i/o, isn' t ? >>Are you really sending the debug output for port 0 of WINBOND 87364 ? >> >> >> > >Yes, I am sending to the serial port on the superio chip, not the >internal UART of GX/CS5535. > >Ollie > > > > -- linuxbios mailing list [email protected] http://www.openbios.org/mailman/listinfo/linuxbios
