On 12/1/06, Peter Stuge <[EMAIL PROTECTED]> wrote: > On Thu, Nov 30, 2006 at 07:44:47PM -0600, Bari Ari wrote: > > Someone could fab these however as a 2 sided pcb with only the > > SMBus signals for next to nothing in cost. > > I looked into this yesterday. > > The place I normally order prototype boards from (Olimex) don't stock > any 1.2mm laminate. > > The place I order production boards from (local fab) do have 1.2mm > laminate but the minimum order they do is one full panel (about .5m2) > - that means a big bag of boards. :) > > If there's interest I'll be happy to make a DDR2 board that does high > speed SPD<->USB. > > I estimate they would go at $150 assembled or a bit cheaper as kits. > (All SMD though.) > > I need about 20 orders before starting it up, then roughly two months > until they're shipping. > > This is pretty special-purpose though. Perhaps time would be better > spent on the LPC thingy, since they can be used for testing too.
I am missing something here. If we have enough of PCI up to do SPD->USB, I would bet that we have enough of it up to do USB debug? or not? LPC is going away on many boards, I understand. I think that we are going into a world where we have to figure out usb debug port. I don't think that the PCI initial setup for USB debug is going to be impossible -- the vendors have to debug these boards too. All the boards I have used lately have a very straightforward path to USB, that could be set up in the ROMCC or CAR code. ron -- linuxbios mailing list [email protected] http://www.openbios.org/mailman/listinfo/linuxbios
