Interrupts still doesn't work? Try cat /proc/interrupts or /var/log/messages to see if it get interrupt.
YH -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: Tuesday, December 12, 2006 12:22 PM To: Lu, Yinghai; [email protected] Subject: Re: [LinuxBIOS] DK8-HTX Early Hang with HTX Card Intsalled > You can use 2.6.19 later kernel and enable HT_IRQ in it. --- Eric worked > it out, and I didn't have chance to test it. Hey, 2.6.19.1 actually boots (better than 2.6.19)! 2.6.19.1 with HT_IRQ turned on yields: sh-3.1# modprobe ib_ipath PCI: No IRQ known for interrupt pin C of device 0000:40:01.0. Probably buggy MP table. mtrr: type mismatch for fd500000,100000 old: write-back new: write-combining ib_ipath 0000:40:01.0: mtrr_add() WC for PIO bufs failed (-22) ib_ipath 0000:40:01.0: infinipath0: Write combining not enabled (err 22): performance may be poor Note that HT_IRQ removes the complaint (formerly right before the mtrr complaints): ipath_core 0000:40:01.0: infinipath0: irq is 0, BIOS error? Interrupts won't work Further fun stuff to try? I am your board monkey. -mcq -- [EMAIL PROTECTED] -- http://www.fastmail.fm - Same, same, but different... -- linuxbios mailing list [email protected] http://www.openbios.org/mailman/listinfo/linuxbios -- linuxbios mailing list [email protected] http://www.openbios.org/mailman/listinfo/linuxbios
