Can you program the flash chip in your 860 board using mtd?
I'm trying to do this for my 815ep board but I fail to do this.
when i load physmap.o, i got following message and fail to load it.
--
Dec 2 22:59:27 hcyun kernel: physmap flash device: 0 at 0
--
As you know, both 860 and 815ep use same FWH. So i think if you can do this, you can tell me how to do.
if you are successful for this, plz tell me how to configure mtd.
And one more question, does your "cache as ram" works fine on PIII ?
If it has no problem, i think it's much better to rewrite my 815ep codes using C.
Wring code in no stack environment is terribly complicate.
-
HeeChul Yun,
Researcher, Embedded S/W Team at ETRI
e-mail: [EMAIL PROTECTED]
phone: +82-42-860-1673
