Hi, Stephan, Thanks for the information. By changing the ROM_SIZE in the Config.lb, I get a linuxbios.ROM of 524288 bytes and flashed it to the destination node.
After that I connected the null modem cable to another machine, use minicom and configured the serial poart as 115200 8N1, quite and restart the minicom again and then started the machine with linuxbios flashed. But I cannot see any inputs. What could be the problem? Thanks. Xuehua --- Stefan Reinauer <[EMAIL PROTECTED]> wrote: > * Frank Samuel <[EMAIL PROTECTED]> [050916 > 22:04]: > > Before I get BIOS download from IWILL's website. > > The .ROM file is 524288 bytes. Is this the > flash_chip > > size? The linuxbios.rom built is 1048576 bytes. > > Then you probably flashed half of LinuxBIOS only.. > You need to create > one that is 512k big if that is the size of your > flash chip > > > I didn't connect the serial cable to the machine. > And > > do you mean set the baute rate in Bios settings? > > Connect the board with a serial cable to another > machine. you will see > lots of output if LinuxBIOS is there. (i think > 115200 baud is the > default) > VGA is still a bit tricky in LinuxBIOS > > > Stefan > > -- > LinuxBIOS mailing list > [email protected] > http://www.openbios.org/mailman/listinfo/linuxbios > __________________________________ Yahoo! Mail - PC Magazine Editors' Choice 2005 http://mail.yahoo.com -- LinuxBIOS mailing list [email protected] http://www.openbios.org/mailman/listinfo/linuxbios
