Hello All,
Some months back when there was a discussion on using a caching name
server so at that time I used the local package manager to install bind
and co. but at that time something had happened and the system went into
a runaway process with the HDD continuously active. After a forced
restart, the package manager showed bind and co. ticked (installed) but
they are actually not in the system. When I uncheck to remove the
packages, it gives an error that these packages were not found.
Today I tried it out again but same result. So now I used yumx and
selected 3 packages bind, caching-nameserver and chrootbind(?). This
time too the system went into a tizzy and the hdd was running
continuously and even the screen froze and went hollow (only outlines,
no solids). Again I had to force restart.
Is there any way I can clean up my act without a clean re-install?
Thanks in advance and Regards,
Rony.
___________________________________________________________
Yahoo! Photos NEW, now offering a quality print service from just 8p a photo http://uk.photos.yahoo.com
--
http://mm.ilug-bom.org.in/mailman/listinfo/linuxers
