+ - fsl,fullspeed-clock : specifies the full speed USB clock
source in
+ "clk<num>" or "brg<num>" format.
+ - fsl,lowspeed-clock : specifies the low speed USB clock source
in
+ "clk<num>" or "brg<num>" format.
What format is "<num>" in?
+ - fsl,usb-mode : should be "host".
If that's the only possible value, this property is unnecessary,
no? It probably would make sense to make this optional (and default
to "host") anyway.
+ - linux,hub-power-budget : optional, USB power budget for the
root hub
+ in mA.
Why is this linux-specific?
+ w) Freescale MCU with MPC8349E-mITX compatible firmware
+
+ Required properties:
+ - compatible : "fsl,<mcu-chip>-<board>", "fsl,mcu-mpc8349emitx";
+ - reg : should specify I2C address (0x0a).
+ - #address-cells : should be 0.
+ - #size-cells : should be 0.
+ x) Freescale Localbus UPM programmed to work with NAND flash
Similar here, except this one is never a GPIO controller.
If the point to have #a = #s = 0 is to not have a unit-address
in the child nodes: you should do that simply by not specifying
a "reg" in the child nodes.
+ y) LEDs on GPIOs
This one is so full of "linux," stuff that I won't review it --
I wouldn't know where to start, sorry.
Segher
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-dev
