On 7/31/08, Timur Tabi <[EMAIL PROTECTED]> wrote: > Jon Smirl wrote: > > > For mpc5200 it is easy, mpc52xx_find_ipb_freq() already exists to get > > the source clock for the i2c devices. Each i2c node in the device tree > > can then specify "clock-frequency = 400000;" or let it default. You > > > 400KHz is the *speed* of the I2C bus, so let's be sure to use "speed" in the > property name. Reserve the word "bus" for the input clock to the I2C device. > > > > #if defined(CONFIG_MPC8540) || defined(CONFIG_MPC8541) || \ > > defined(CONFIG_MPC8560) || defined(CONFIG_MPC8555) > > gd->i2c1_clk = sys_info.freqSystemBus; > > #elif defined(CONFIG_MPC8544) > > /* > > * On the 8544, the I2C clock is the same as the SEC clock. This > can be > > * either CCB/2 or CCB/3, depending on the value of cfg_sec_freq. > See > > * 4.4.3.3 of the 8544 RM. Note that this might actually work for > all > > * 85xx, but only the 8544 has cfg_sec_freq, so it's unknown if the > > * PORDEVSR2_SEC_CFG bit is 0 on all 85xx boards that are not an > 8544. > > */ > > if (gur->pordevsr2 & MPC85xx_PORDEVSR2_SEC_CFG) > > gd->i2c1_clk = sys_info.freqSystemBus / 3; > > else > > gd->i2c1_clk = sys_info.freqSystemBus / 2; > > #else > > /* Most 85xx SOCs use CCB/2, so this is the default behavior. */ > > gd->i2c1_clk = sys_info.freqSystemBus / 2; > > #endif > > gd->i2c2_clk = gd->i2c1_clk; > > > I think the whole point is to eliminate duplicating this code in the Linux > driver. It's hideously ugly, so it should be limited as much as possible.
It wouldn't go into the i2c driver, it would go into the mpc8xxx platform driver. Why is it bad to put it into the mpc8xxx platform driver? It is an accurate description of the mpc8xxx platform isn't it? -- Jon Smirl [EMAIL PROTECTED] _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-dev
