The current documentation implies that pci_epc_set_bar() is only used before the host enumerates the endpoint.
In practice, some Endpoint Controllers support calling pci_epc_set_bar() multiple times for the same BAR (without clearing it) in order to update inbound address translations after the host has programmed the BAR base address, which some Endpoint Functions such as vNTB already relies on. Add document text for that. Also document the expected call flow for BAR subrange mapping (pci_epf_bar.use_submap / pci_epf_bar.submap), which may require a second pci_epc_set_bar() call after the host has programmed the BAR base address. Signed-off-by: Koichiro Den <[email protected]> --- Documentation/PCI/endpoint/pci-endpoint.rst | 22 +++++++++++++++++++++ 1 file changed, 22 insertions(+) diff --git a/Documentation/PCI/endpoint/pci-endpoint.rst b/Documentation/PCI/endpoint/pci-endpoint.rst index 0741c8cbd74e..d3d9abbbc71e 100644 --- a/Documentation/PCI/endpoint/pci-endpoint.rst +++ b/Documentation/PCI/endpoint/pci-endpoint.rst @@ -95,6 +95,28 @@ by the PCI endpoint function driver. Register space of the function driver is usually configured using this API. + Some endpoint controllers also support calling pci_epc_set_bar() again + for the same BAR (without calling pci_epc_clear_bar()) to update inbound + address translations after the host has programmed the BAR base address. + Endpoint function drivers can check this capability via the + dynamic_inbound_mapping EPC feature bit. + + When pci_epf_bar.use_submap is set, the endpoint function driver is + requesting BAR subrange mapping using pci_epf_bar.submap. This requires + the EPC to advertise support via the subrange_mapping EPC feature bit. + + If the EPF driver wants to program inbound subrange mappings that are + based on the BAR base address programmed by the host during enumeration, + it needs to call pci_epc_set_bar() twice for the same BAR (requires + dynamic_inbound_mapping): first with use_submap cleared to configure the + BAR size, then after the PCIe link is up and the host enumerates the + endpoint and programs the BAR base address, again with use_submap set. + + Note that in this flow, the EPF driver must not call pci_epc_clear_bar() + between the two pci_epc_set_bar() calls, because clearing the BAR can + clear/disable the BAR register or BAR decode on the endpoint while the + host still expects the assigned BAR address to remain valid. + * pci_epc_clear_bar() The PCI endpoint function driver should use pci_epc_clear_bar() to reset -- 2.51.0
