On Sat, 2010-12-04 at 05:49 -0700, Gary Thomas wrote: > On 11/23/2010 07:44 AM, Gary Thomas wrote: > > On 11/22/2010 01:26 PM, Benjamin Herrenschmidt wrote: > >> On Mon, 2010-11-22 at 03:01 -0700, Gary Thomas wrote: > >>> I have a bit more information on this. I'm pretty sure that the failures > >>> are only happening in my SCSI (SATA actually) code. My board (8347ea) > >>> has > >>> a PCI bus with a SIL SATA controller. This combo works perfectly in > >>> 2.6.28. > >>> In 2.6.32, it will run for a while (possibly quite a while), then > >>> timeout > >>> trying to do a large block write - typically 256 blocks. Once this > >>> timeout > >>> happens, the SIL controller is stuck and accesses to it will eventually > >>> cause the whole system to hang (as above). > >>> > >>> Was there any major change in how PCI or DMA was handled between 2.6.28 > >>> and 2.6.32? Given the ephemeral nature of these failures (multiple runs > >>> all eventually fail, but never the same twice), my only hope of > >>> fixing it > >>> will be to have some ideas what might have changed. > >> > >> Maybe the changes you did to the PCI outbound windows are now breaking > >> DMA ? Make sure the outbound and inbound don't overlap for example and > >> that all RAM is reachable for inbound. > > > > Here's what I did to work around this - in my DTS, I set up my PCI as > > ranges = <0x02000000 0x0 0xC4000000 0xC4000000 0x0 0x1C000000 > > 0x01000000 0x0 0x00000000 0xB8000000 0x0 0x00100000>; > > Before, I had it as > > ranges = <0x02000000 0x0 0xC0000000 0xC0000000 0x0 0x20000000 > > 0x01000000 0x0 0x00000000 0xB8000000 0x0 0x00100000>; > > > > I wasn't sure how to reserve the memory (based on your earlier suggestion), > > so I just narrowed the window. Note that I did not change the PCI hardware > > registers (maybe the FSL code does?), so the outbound window should still > > be the whole 512MB. > > > > If this isn't viable, perhaps you could explain a bit more how to reserve > > such a chunk of memory so that the PCI mappings remain the same. > > Any ideas on this? I'm a bit lost as to how to reserve the memory like > you suggested and what I've tried so far has met little success. > > Thanks again >
Look at pcibios_reserve_legacy_regions() in arch/powerpc/kernel/pci-common.c, it "reserves" the legacy IO and VGA regions on host bridges. You can make it reserve whatever your device is allergic too. Cheers, Ben. _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@lists.ozlabs.org https://lists.ozlabs.org/listinfo/linuxppc-dev