On 01/24/11 04:26, tiejun.chen wrote:
Elie De Brauwer wrote:
Hello list,
I have a P2020 processor on a custom board which uses the embedded
fsl-esdhc controller. Hardware-wise this is functional and in u-boot
everything seems to behave (mmc part 0 gives the correct partition table
and ext2ls/fatls are capable of reading the contents of the sd card).
However as soon as I start Linux (2.6.36), I get all sorts of unwanted
behavior. Linux is unable to detect the partition layout (but if I do a
Can you re-partition that under Linux? i.e, you can use fdisk to do this. Then
I'm a bit curious what it'll be happened.
This was already partitioned under (x86) Linux, and when I plug it into
my laptop it sees the MBR (but also on target, in U-boot, the mmc part 0
command shows the correct partition table). And this does not explain
why the card registers (such as the scr pasted below) also seem to have
their endianess swapped, which will result in other side-effects, such
as improper reading of card capabilities.
hexdump of the MBR, I see the endianness is swapped (last 4 bytes are aa
55 00 00). Also when I try to obtain the card registers they show the
same behavior:
# cat ./devices/soc.0/ff72e000.sdhci/mmc_host/mmc0/mmc0:0001/scr
0000b50200000000
While for comparison the same value on my (x86) laptop gives:
edb@lapedb:/sys/devices/pci0000:00/0000:00:1e.0/0000:15:00.2/mmc_host/mmc0/mmc0:0001$
cat scr
02b5000000000000
In my config I have the following set:
CONFIG_MMC_SDHCI=y
CONFIG_MMC_SDHCI_IO_ACCESSORS=y
CONFIG_MMC_SDHCI_BIG_ENDIAN_32BIT_BYTE_SWAPPER=y
# CONFIG_MMC_SDHCI_PCI is not set
CONFIG_MMC_SDHCI_OF=y
CONFIG_MMC_SDHCI_OF_ESDHC=y
At least looks the config is fine.
Tiejun
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev
