In message <[EMAIL PROTECTED]> you wrote: > > The new unit works *mostly* fine. No debugging issue (not that I use it that > much anyway, now that the board boots Linux), but still a flash programming > issue. Programming the target parallel NOR flash works in slow JTAG mode, but > not in faster mode using the internal workspace. I reported the problem
This may as well be a misconfiguration in your config file, like setting wrong flash timings. > several months ago and still haven't received any solution. It might not be > Abatron's fault, the French distributor might not have reported the problem > to them. Abatron people speak German only, and will not respond to e-mails > written in English (nor will they talk to you on the phone, they just hang > up). I cannot confirm this. On contrary. Abatron's support is one of the best I've ever seen, and I have seen a few. And of course you can send messages in English to [EMAIL PROTECTED], and you do get replies. And they do answer the phone (in German and in English, too). > The BDI-2000 is a nice product, but has a few bugs, is IMHO overprized and > has > one of the worst support service I've had to deal with. Hm... we have about 15 such devices in daily use. I don't doubt your report, but you must have had really bad luck. This is NOT the normal situation with Abatron or the BDI. Best regards, Wolfgang Denk -- Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [EMAIL PROTECTED] In Nature there are neither rewards nor punishments, there are conse- quences. -- R.G. Ingersoll _______________________________________________ Linuxppc-embedded mailing list [email protected] https://ozlabs.org/mailman/listinfo/linuxppc-embedded
