Hi there,
I'm having a problem when using gdb to debug an application via the gdbserver. It seems the gdbserver crashes when I issue "continue" command (the target just hangs, no response, no messages on the Linux console). This is what I'm getting on the gdb side (I'm using verbose and debug modes): (gdb) continue Continuing. Sending packet: $Z0,100004dc,4#02...Ack Packet received: Packet Z0 (software-breakpoint) is NOT supported Sending packet: $m100004dc,4#b9...Ack Packet received: 3d201000 Sending packet: $X100004dc,0:#da...Ack Packet received: binary downloading NOT suppported by target Sending packet: $M100004dc,4:7d821008#a1...Ack Timed out. Timed out. Timed out. Ignoring packet error, continuing... Sending packet: $m3000c380,4#8e...Sending packet: $m3000c380,4#8e...Sending packet: $m3000c380,4#8e...Sending packet: $m3000c380,4#8e...Timed out. Timed out. Timed out. Ignoring packet error, continuing... Reply contains invalid hex digit 116 Here are a few words about my setup: I'm using an Arabella 2.6.12 custom kernel that contains USB support. Everything is working fine (Except for this problem). I'm using the new DENX 4.1 toolchain to compile both my kernel & application. I'm using Fedora desktop to run the gdb and the gdbserver is on my custom MPC880 board. I'm using IP to connect the gdb to gdbserver. I'm following the exact guidelines described on DENX web site. In order to simplify the problem I'm using a simple "hello world" program. Any ideas? Thanks. Ami Levi
_______________________________________________ Linuxppc-embedded mailing list [email protected] https://ozlabs.org/mailman/listinfo/linuxppc-embedded
