In message <[EMAIL PROTECTED]> you wrote:
>
> I have multiple boards, based on ppc405ep (which include on-chip two
> ethernet ports). I'm configure the MAC address in u-boot and all works
You should post U-Boot related questions to the U-Boot-Users mailing
list. They are off topic here.
> great. The problem appears when I use two or more boards in one network,
> because the MAC addresses are the same. Now I'm making a own u-boots for
> each board, but this solution is not very comfortable.
Maybe you should start reading the manual and get a clue about the use
of environment variables in U-Boot.
> My question is, which is the standard way to resolve such problem? I
> would have only one generic u-boot. Is this possible?
Of course it is. Just use different settings of the ethaddr
environment variables.
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, HRB 165235 Munich, CEO: Wolfgang Denk
Office: Kirchenstr. 5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [EMAIL PROTECTED]
It is dangerous to be sincere unless you are also stupid.
- George Bernard Shaw
_______________________________________________
Linuxppc-embedded mailing list
[email protected]
https://ozlabs.org/mailman/listinfo/linuxppc-embedded
