Aubrey Lee wrote:
> hi, In the PC(i686) system, I build and run zebra successfully. And now
>I'm porting it to the powerpc system. Cross-compiling finished without error.
>But when I run the zebra from my target board, it gives me a big headache:
>--------------------------------------------------------------------------
>bash-2.05b# /opt/zebra/sbin/zebra
> sock: Address family not supported by protocol
>----------------------------------------------------------------------------
>And Up to now I cann't find the message in the souce
>code files.
> The two ethx and their driver of my board is OK.
> What shall I do?
>
>
I had a similar message when running udhcpd. The problem was that some
network drivers were built as modules. Adding the following to
modules.conf cured my problem:
# PF_PACKET support needed by udhcpc
alias net-pf-17 af_packet
--
Mark Powell, Senior Software Engineer
Curtiss-Wright Controls Embedded Computing
Tel: +44 (0) 1763 852222
Email: medp at primagraphics.com
