Hi Does your kernel cmdline includes the "console=ttyS0" ? It's mandatory here while with DENX's kernel it may not be.
The initscript are not even launched at that point ... Sylvain Linas Petras wrote: >Hi All > >I'm running Sylvain Munaut's version of 2.6.10-rc2 with DENX's 3.1 ELDK as >the cross >compile tools with nfs mounted root filesystem and I seem to have a probelm >when I'm >connected to the "icecube" development boards serial port. > >I get the u-boot 1.1.3 bootrom messages from the serial port on the >"icecube" and can >boot the kernel using the serial port but I don't get any messages after the >early >boot message "arch: exit". It appeared to me that the board was booting so I >tried to >telnet via the network to the board and this worked fine. So the kernel is >running, I >just don't get the "normal" bootup messages from the kernel. > >If I use the standard DENX 2.4.25 kernel I get all the message going to the >serial >port OK. > >Any ideas of whats going on ????? Is their a problem with the console >support in >Sylvain's port or something in the "standard" init scripts that come with >DENX's ELDK >3.1 when used with a 2.6.xx kernel or have I missed something obvious? > >Linas Petras >------------ >I know not with which weapons World War III will be faught, but World War IV >will be faught with sticks and stones. - Albert Einstein. > >_______________________________________________ >Linuxppc-embedded mailing list >Linuxppc-embedded at ozlabs.org >https://ozlabs.org/mailman/listinfo/linuxppc-embedded > > >
