Hi zhonglei, zhonglei wrotes on Dienstag, 30. November 2004 12:50: > Thank you! > After enabled SCSI support and SCSI disk support,I can enable > USB mass storage devices . I enabled USB mass storage support > and reboot my kernel.The system run into a deadlock!
Sorry, I haven't tested usb mass storage support on the lite5200, so I could not tell if it works. > U-Boot 1.1.2 (Nov 12 2004 - 11:46:06) > > CPU: MPC5200 v1.2 at 462 MHz The cpu clock seems a bit fast to me. AFAIR the maximum is 400 MHz for actual cpu revisions. > Bus 132 MHz, IPB 132 MHz, PCI 33 MHz > Board: Motorola MPC5200 (IceCube) > I2C: 85 kHz, ready > DRAM: 64 MB > FLASH: 16 MB > PCI: Bus Dev VenId DevId Class Int > 00 1a 1057 5803 0680 00 > In: serial > Out: serial > Err: serial > Net: FEC ETHERNET > IDE: Bus 0: OK > Device 0: Model: Flash Card Firm: 2N3-0925 Ser#: CF00000000 > Type: Removable Hard Disk > Capacity: 123.0 MB = 0.1 GB (251904 x 512) Device 1: > not available > > Autostarting.Press any key to abort.. > > Hit any key to stop autoboot: 0 > Using FEC ETHERNET device > TFTP from server 198.87.102.60; our IP address is 198.87.102.210 > Filename 'MPC5200/uImage'. Load address: 0x100000 > Loading: > ################################################################# > > ################################################################# > ################################################# > done > Bytes transferred = 914801 (df571 hex) > ## Booting image at 00100000 ... > Image Name: Linux-2.4.25 > Image Type: PowerPC Linux Kernel Image (gzip compressed) > Data Size: 914737 Bytes = 893.3 kB > Load Address: 00000000 > Entry Point: 00000000 > Verifying Checksum ... OK > Uncompressing Kernel Image ... OK > > What can I do next? A good starting point for error searching is the FAQ-Section in the DULG: http://www.denx.de/twiki/bin/view/DULG/Manual Regards, Martin
