What processor frequency do you use ? The EP board for 852T uses 10 MHz OSCM and CLKIN. We were trying 66 MHz earlier and 25Mhz after that. But never got any results. The hardware is clean afaik. and the memory timing is more critical on the MPC8280 on the same board and it works very well.
We tried changing the clock source to oscillator/crystal and slowing the clockout to the SDRAM to verify if memory access were a problem. But no result there too. The kernel we have is 2.4.21. Will migrating to 2.6 make lives any better ? Best, Akshay ----------Quoting Kenneth We have been experiencing this same issue with random boards in production. The exact same version of software will run for months on other instances of the exact same board design, but a few percent get 'random' trap 300s. When they do occur, it's only after Linux has booted and address translation and caching are turned on. Examining the oops-es and memory shows that some location in SDRAM has a bogus value, but I don't have the tools to trace back how it got that way. I have ported a rigorous moving-inversions memory test into our firmware, and have run it extensively across the entire SDRAM address space (the test code executes from flash). I have let this test run continuously for hours and hours, but never found a memory problem. Unfortunately, I do not have test software that enables the MMU address translation or caching, so as Mark said, I can't test memory using bursting. Our hardware engineers have reviewed the designs very carefully and are quite confident that there is plenty of margin in the memory timing. Signal quality has also been carefully checked. Our manufacturing people have replaced the CPU on some of these boards, and the problem went away. If anyone else on the mailing list has experienced this issue, or has developed a virtual address memory test, please let us know. Ken Poole
