srideep.devireddy at wipro.com wrote: > > > Hi , > > > > we were able to get the u-boot up on MPC8272ADS board . We are just > struck up in bringing up the Linux... we get the following errors .. > actually we made a uImage from vmlinux and tried to tftp and used bootm > 100000 , we eneded up with these errors ...actually after the message > Uncompressing Kernel Image ... OK board gets reset .Any help would be > thankfull. > I can suggest to try the current 2.6, on which 8272 is supported and known to work. A problem with binary you got is possibly because of configuration incompatibility of your u-boot and kernel binary.
> > > > > *=> tftp 100000 vmlinux.72* > > *Using FCC1 ETHERNET device* > > *TFTP from server 10.0.0.1; our IP address is 10.0.0.2* > > *Filename 'vmlinux.72'.* > > *Load address: 0x100000* > > *Loading: #################################################################* > > * #################################################################* > > * #######################* > > *done* > > *Bytes transferred = 782424 (bf058 hex)* > > *=> bootm 100000* > > *## Booting image at 00100000 ...* > > * Image Name: Linux-2.4.22* > > * Image Type: PowerPC Linux Kernel Image (gzip compressed)* > > * Data Size: 782360 Bytes = 764 kB* > > * Load Address: 00000000* > > * Entry Point: 00000000* > > * Verifying Checksum ... OK* > > * Uncompressing Kernel Image ... OK* > > * > > * > > * > > * > > *U-Boot 1.1.1 (Nov 8 2005 - 16:19:13)* > > * > > * > > *MPC8272 Reset Status: Check Stop, External Soft, External Hard* > > * > > * > > *MPC8272 Clock Configuration* > > * - Bus-to-Core Mult 3.5x, VCO Div 2, 60x Bus Freq 30-85 , Core Freq > 100-300* > > * - dfbrg 1, corecnf 0x1e, busdf 3, cpmdf 1, plldf 0, pllmf 3* > > * - vco_out 400000000, scc_clk 100000000, brg_clk 25000000* > > * - cpu_clk 350000000, cpm_clk 200000000, bus_clk 100000000* > > * - pci_clk 66666666* > > * > > * > > *CPU: MPC8272 (HiP7 Rev 14, Mask A.0 1K50M) at 350 MHz* > > *Board: Motorola MPC8272ADS* > > *DRAM: 64 MB* > > *FLASH: 8 MB* > > *In: serial* > > *Out: serial* > > *Err: serial* > > *Net: FCC1 ETHERNET* > > *Hit any key to stop autoboot: 0* > > *=>* > > > > > > Best Regards > > > > Srideep > > > > > Confidentiality Notice > > The information contained in this electronic message and any attachments > to this message are intended > for the exclusive use of the addressee(s) and may contain confidential > or privileged information. If > you are not the intended recipient, please notify the sender at Wipro or > Mailadmin at wipro.com immediately > and destroy all copies of this message and any attachments. > > > ------------------------------------------------------------------------ > > _______________________________________________ > Linuxppc-embedded mailing list > Linuxppc-embedded at ozlabs.org > https://ozlabs.org/mailman/listinfo/linuxppc-embedded -- Sincerely, Vitaly
