Hi all
I am using ELDK to port linux to a simple MPC860T board. I use SMC1 to
connect to the serial port and as the console.But I can't go any further
because when i powerup,the console doesnot show any message.List my steps
here:
1. edit ~/.kermrc as what was shown in <Denx ppcboot and linux
Guide(tqm8xxl)>.
2. modify several line of 'TQM860L.h'.
3. modify my UPM table and register OR1/BR1 to OR4/BR4(my sdram uses
cs4) in the file tqm8xx.c.
4. bash>make distclean.
5. bash>make TQM860L_config.
7. bash>make all
8. use a flash programmer to burn the u-boot.bin to my boot flash.
9. bash>kermit -c
Connecting to /dev/ttyS0, speed 115200
Escape character:xxxxxxxxxxxxxxx :enabled
Type xxxxxxxxxxxxxxxxxxxxxxxxxxx to got back
or xxxxxxxxxxxxxxxxxxxxxxxxxxxxx options
--------------------------------------
10.power up,but nothing is output.
PS:my board info:MPC860T/SCC1 ETHERNET/SMC1 Serial/PCMCIA/CS0 FLASH 0/CS4
SDRAM
It's my first time to build a embedded linux project,wish u can help me out.
Thanks a lot!
Best regards!
--http://www.eyou.com
--?????????????????????? ???????? ???????? ???????? ????????...????????
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
