Well, to cancel any baud rate problems I zeroed the CDV field in the BRG register so it defaults to 115000. So when I use the ppc boot as is with MPSC uart and baud rate of 115000, I listen to the Tx line with a scope and see nothing !, what am I doing wrong ??
-----Original Message----- From: Wolfgang Denk [mailto:[EMAIL PROTECTED] Sent: Tuesday, February 26, 2002 3:18 PM To: Tzahi Oved Cc: 'linuxppc-embedded at lists.linuxppc.org' Subject: Re: ppcboot 1.1.4 & MPSC In message <20083A3BAEF9D211BDB600805F8B14F3010A15AB at NTSERVER> you wrote: > > I'm trying to work with the internal uart (MPSC) on the Galileo EVB64260 > board. When I set the definition CONFIG_MPSC in the EVB64260 config file > (which supposed to set the terminal to work on the MPSC) I'm not getting any > response on my console, do I need to configure anything else ?? any This can be anything, like just bad baudrate settings. You need to be more specific about your setup. And you have better chances for a useful reply on the ppcboot-users mailing list. Wolfgang Denk -- Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: wd at denx.de Cole's Law: Thinly sliced cabbage. ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
