Can somebody point to a similar driver code, to control mic2563, which is memory mapped on mpc8xx board, with cs#4 as chip select? Any template driver code would be helpful as well.
Lokesh -----Original Message----- From: Lokesh Kumar Sent: Friday, August 29, 2003 8:24 AM To: 'Graf Alex'; Lokesh Kumar; linuxppc-embedded at lists.linuxppc.org Subject: RE: mic2563 dual slot pcmcia controller I have 2.4.18 kernel, and is booted by u-boot 0.4. However, I do not think that I should do any init of pcmcia controller from the u-boot, because u-boot does not use it and hence should not init it. I want to init it inside the kernel. I thought m8xx_setup.c and m8xx_pcmcia.c is a better place to do all my chip select for controlling mic2563 and the other pcmcia related settings. Lokesh -----Original Message----- From: Graf Alex [mailto:[EMAIL PROTECTED] Sent: Friday, August 29, 2003 2:55 AM To: 'Lokesh Kumar'; linuxppc-embedded at lists.linuxppc.org Subject: AW: mic2563 dual slot pcmcia controller Hello I did setup the second PCMCIA Slot on a MPC855. The bootloader (u-boot) setups the pbrX, porX, ... registers. The kernel lives with this values. Which Kernel do you have? For me was the /drivers/ide/ide-m8xx.c the most important file (I needed CF support). Cheers Alex -----Urspr?ngliche Nachricht----- Von: Lokesh Kumar [mailto:lokesh.kumar at wrx-us.com] Gesendet: Donnerstag, 28. August 2003 20:45 An: linuxppc-embedded at lists.linuxppc.org Betreff: mic2563 dual slot pcmcia controller Hi, I have a mpc8xx based board, which has two pcmcia slots, and uses micrel 2563a power controller. Now, I understand that I have to control this in the file drivers/pcmcia/m8xx_setup.c file. I was wondering if anybody has done the same and can tell me what is the right way. Also, where do I set the other pcmcia related values for example pbr0, memory size etc? Any pointers would be helpful. Thanks in advance. Lokesh Kumar Wireless Matrix USA Inc. 703-262-4032 ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
