In message <20030908145948.75210.qmail at web41410.mail.yahoo.com> you wrote: > > Does anyone have PPCBoot and ELDK up an running on an > EP862 board? > > I have PPCBoot working with SDRAM and Flash, but when
Please note that PPCBoot is a dead project. You are wasting your time. Please use the successor project U-Boot instead. > I compile it to read the environment variables from > the EEPROM, it won't boot. Does anyone have this > working? Works fine on many boards. > I can however get it to boot if I compile it to get > its environment variables from flash (it just > complains and then loads some defaults). However, > when I TFTP ELDK over to the EP862 and "GO 00400000", > it complains. As it should. "go" is not the command used to boot a Linux kernel image. > What is the proper way to create the zImage for > PPCBoot (U-Boot)? It's a two-step procedure. The first step is reading the documentation, i. e. especially the README and then the DULG - see http://www.denx.de/twiki/bin/view/DULG/Manual The second step is using "make uImage" in you kernel tree (or "make pImage" if the new alias is still not there). Finally, please note that this is off topic here. Please send such requests to the u-boot-users mailing list instead. Best regards, Wolfgang Denk -- Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: wd at denx.de I am a computer. I am dumber than any human and smarter than any ad- ministrator. ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
