Hi
I have a set of 8 1GB data flash chips (Samsung) on an MPC8245 Ref. Board.
These are on a 64-bit bus-mode.
-------DBUS_SIZ[0-1]:DBUS_SIZ[2] = 110b -------
All 8 chips are selected by a single chip select (RCS1). Trying a 32-bit read
from the Data Address Location after giving the Command to Access the flash
IDs, only 4 flashes on a common byte lane seem to be responding. 32-bit writes
appear only on the DH[0-31] and not on DL[0-31].
I am not very clear as to:
(a) How do we perform writes to send out data out on
all 64-bits of the bus..?
(b) How would we ideally access 64-bit data through 32- bit reads..?
(c) Or must we *have* 64- bit read/write
instructions..?
many thanks in advance for any response ..
Regards
Nebu
Need a new email address that people can remember
Check out the new EudoraMail at
http://www.eudoramail.com
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
