Dear Joao, in message <DEF39A0710293E489D45B10E06645CBD0243B3B2 at dub-msx1.spectelcorp.com> you wrote: > > on u-boot IMMR was set to 0x04700000, which is acceptable as far as > u-boot is concerned, but not allowed once the kernel is initialised. > > The other issue was that the Chip Select was not configured properly on > u-boot (2MB instead of 32MB), which was not noticed in u-boot since the > u-boot never tried to access memory above that region, but caused the > kernel to reset the target. ... > I am using the denx distribution linuxppc_2_4_devel, and I am > configuring it using the TQM8260 default configuration, customising some > CPM settings for UART and FEC.
I would like to point out that you certainly did NOT pick up such a bogus memory map from the TQM8260 default configuration, nor from any other board maintened by DENX. Best regards, Wolfgang Denk -- Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: wd at denx.de Old programmers never die, they just branch to a new address. ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
