Hi, this patch fixes the problem, that the current kernel (linux-2.6.11-rc5) could not be compiled, when "support for early boot texts over serial port" (CONFIG_SERIAL_TEXT_DEBUG=y) is active.
Signed-off-by: Gerhard Jaeger <gjaeger at sysgo.com> --- linux-2.6.11-rc5/arch/ppc/platforms/4xx/ebony.h.orig 2005-02-28 16:55:15.000000000 +0100 +++ linux-2.6.11-rc5/arch/ppc/platforms/4xx/ebony.h 2005-02-28 16:55:56.000000000 +0100 @@ -61,8 +61,8 @@ */ /* OpenBIOS defined UART mappings, used before early_serial_setup */ -#define UART0_IO_BASE (u8 *) 0xE0000200 -#define UART1_IO_BASE (u8 *) 0xE0000300 +#define UART0_IO_BASE 0xE0000200 +#define UART1_IO_BASE 0xE0000300 /* external Epson SG-615P */ #define BASE_BAUD 691200 --- linux-2.6.11-rc5/arch/ppc/platforms/4xx/luan.h.orig 2005-02-28 16:55:07.000000000 +0100 +++ linux-2.6.11-rc5/arch/ppc/platforms/4xx/luan.h 2005-02-28 16:55:43.000000000 +0100 @@ -47,9 +47,9 @@ #define RS_TABLE_SIZE 3 /* PIBS defined UART mappings, used before early_serial_setup */ -#define UART0_IO_BASE (u8 *) 0xa0000200 -#define UART1_IO_BASE (u8 *) 0xa0000300 -#define UART2_IO_BASE (u8 *) 0xa0000600 +#define UART0_IO_BASE 0xa0000200 +#define UART1_IO_BASE 0xa0000300 +#define UART2_IO_BASE 0xa0000600 #define BASE_BAUD 11059200 #define STD_UART_OP(num) \ --- linux-2.6.11-rc5/arch/ppc/platforms/4xx/ocotea.h.orig 2005-02-28 16:55:29.000000000 +0100 +++ linux-2.6.11-rc5/arch/ppc/platforms/4xx/ocotea.h 2005-02-28 16:56:14.000000000 +0100 @@ -56,8 +56,8 @@ #define RS_TABLE_SIZE 2 /* OpenBIOS defined UART mappings, used before early_serial_setup */ -#define UART0_IO_BASE (u8 *) 0xE0000200 -#define UART1_IO_BASE (u8 *) 0xE0000300 +#define UART0_IO_BASE 0xE0000200 +#define UART1_IO_BASE 0xE0000300 #define BASE_BAUD 11059200/16 #define STD_UART_OP(num) \
