Hello, Greg, I am working on an mpc8540_ads-like board and recently, I ran into data corruption problems with a Silicon Motion SM501 (Rev AA) PCI graphics card. From my current point of view it seems that Kernel 2.6.11 PCI works well. I am about to check the hardware and signal integrity.
BTW: I am working with a Promise Ultra-TX133 IDE controller (PDC20269) which is fine with 66MHz PCICLK. Greets, Clemens > Has anyone else tried to get the PCI bus working on the mpc8560ads board > at 2.6.11? The card enumerates, but the I/O resource regions aren't > getting set up. > > -bash-2.05b# lspci -vv > 00:03.0 Unknown mass storage controller: Silicon Image, Inc. (formerly > CMD Technology Inc) PCI0680 Ultra ATA-133 Host Controller (rev 02) > Subsystem: Silicon Image, Inc. (formerly CMD Technology Inc) > PCI0680 Ultra ATA-133 Host Controller > Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- > ParErr- Stepping- SERR- FastB2B- > Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- > <TAbort- <MAbort- >SERR- <PERR+ > Interrupt: pin A routed to IRQ 100 > Region 0: I/O ports at <unassigned> [disabled] > Region 1: I/O ports at <unassigned> [disabled] > Region 2: I/O ports at <unassigned> [disabled] > Region 3: I/O ports at <unassigned> [disabled] > Region 4: I/O ports at <unassigned> [disabled] > Capabilities: [60] Power Management version 2 > Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA > PME(D0-,D1-,D2-,D3hot-,D3cold-) > Status: D0 PME-Enable- DSel=0 DScale=2 PME- > > Greg Weeks > _______________________________________________ > Linuxppc-embedded mailing list > Linuxppc-embedded at ozlabs.org > https://ozlabs.org/mailman/listinfo/linuxppc-embedded > -- Clemens Koller _______________________________ R&D Imaging Devices Anagramm GmbH Rupert-Mayer-Str. 45/1 81379 Muenchen Germany http://www.anagramm.de Phone: +49-89-741518-50 Fax: +49-89-741518-19
