Hi All, I am having custom board which is similar to MPC8260ADS board. I want to port linux on this board. I am having TRACE32 debugger. When i put breakpoint on load_up_mmu, it won't stop at this point. It shows running in the status bar and when i give break, it goes to panic symbol and it hangs there. I cannot proceed further. Then i have to reload the cmm file again. Can any one tell me what and where is the problem. I am using Linux-2.4.25 from denx and my boards memory map is SDRAM 128MB(0x00000000) and Flash 1MB(starts from 0x30000000). Thanks in advance. best regards
Prabha J. Tata Consultancy Services Limited Mailto: prabha.j at tcs.com Website: http://www.tcs.com Notice: The information contained in this e-mail message and/or attachments to it may contain confidential or privileged information. If you are not the intended recipient, any dissemination, use, review, distribution, printing or copying of the information contained in this e-mail message and/or attachments to it are strictly prohibited. If you have received this communication in error, please notify us by reply e-mail or telephone and immediately and permanently delete the message and any attachments. Thank you -------------- next part -------------- An HTML attachment was scrubbed... URL: http://ozlabs.org/pipermail/linuxppc-embedded/attachments/20051213/c321ac95/attachment.htm
