Hello,
I am just about to update my kernel from 2.6.13-rc7 which is working
fine to linus' 2.6.15-rc5-latest git on my mpc8540ads flavored board.
However, the kernel hangs pretty early after
openpic: exit
any ideas or a hint what's wrong there... before I start to
debug deeper into the code?
Thanks,
Clemens
-----8<-----
U-Boot 1.1.3 (Jun 23 2005 - 10:40:01)
CPU: 8540, Version: 2.0, (0x80300020)
Core: E500, Version: 2.0, (0x80200020)
Clocks Configuration:
CPU: 825 MHz, CCB: 330 MHz,
DDR: 165 MHz, LBC: 82 MHz
L1: D-cache 32 kB enabled
I-cache 32 kB enabled
Board: MicroSys PM854
PCI1: 32 bit, 66 MHz (compiled)
I2C: ready
DRAM: Initializing
DDR: 256 MB
FLASH: 32 MB
L2: 256 kB enabled
In: serial
Out: serial
Err: serial
Net: ENET0: PHY is Marvell 88E1111S (1410cc2)
ENET1: PHY is Marvell 88E1111S (1410cc2)
ENET2: PHY is LXT971 (1378e2)
ENET0, ENET1, ENET2
Hit any key to stop autoboot: 0
## Booting image at fe300000 ...
Image Name: Linux-2.6.15-rc5-g7116317d
Created: 2005-12-16 15:30:40 UTC
Image Type: PowerPC Linux Kernel Image (gzip compressed)
Data Size: 1394968 Bytes = 1.3 MB
Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
mpc8540ads_init(): exit
id mach(): done
MMU:enter
MMU:hw init
MMU:mapin
MMU:setio
MMU:exit
setup_arch: enter
setup_arch: bootmem
mpc8540ads_setup_arch()
arch: exit
openpic: enter
openpic: timer
openpic: external
openpic: spurious
openpic: exit
-----8<----
--
Clemens Koller
_______________________________
R&D Imaging Devices
Anagramm GmbH
Rupert-Mayer-Str. 45/1
81379 Muenchen
Germany
http://www.anagramm.de
Phone: +49-89-741518-50
Fax: +49-89-741518-19
