>>eth0: config: auto-negotiation on, 100FDX, 100HDX, 10FDX, 10HDX.
>>IP-Config: Incomplete network configuration information.
>
> You are passing bad/insufficient boot arguments to the Linux kernel;
> unfortunaltely you don;t show us this part of the boot messages, so I
> cannot even guess what you're doing wrong.
Well, if IP-Config is not complete, we can change the configuration
using 'ifconfig' after the kernel starts. I did that. And I noticed that
'eth0' can receive packets but cannot transmit any packets. Here is the
result of running ifconfig.
---------------------------once----------------------------------
#ifconfig
eth0 Link encap:Ethernet HWaddr 00:06:17:01:02:00
inet addr:192.168.5.24 Bcast:192.168.5.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:180 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:18110 (17.6 kb) TX bytes:0 (0.0 b)
Base address:0xe00
---------------------------once----------------------------------
---------------------------twice---------------------------------
#ifconfig
eth0 Link encap:Ethernet HWaddr 00:06:17:01:02:00
inet addr:192.168.5.24 Bcast:192.168.5.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:282 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:26831 (26.2 kb) TX bytes:0 (0.0 b)
Base address:0xe00
---------------------------twice---------------------------------
- Shawn.
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
