Hi all,
Its the bootflash that is mapped at ff800000 so I think i have not much
option but to move PKMAP_BASE which i tried at fc000000 but with no luck .
what could be wrong..
Thanks
Abhishek
-----Original Message-----
From: Karoliya, Abhishek [mailto:[EMAIL PROTECTED]
Sent: Saturday, 1 November 2003 11:42 PM
To: 'invictus rm'
Cc: linuxppc-embedded at lists.linuxppc.org
Subject: RE: 2.4.18mvl30 & 1 GB Board
Hi,
thanks a lot , a spot on solution.. {Should have checked the list...}
that's indeed the case here, with one of the code lines.
"io_block_mapping(0xff800000, 0xff800000, 0x00800000, _PAGE_IO);"
I will check with this modified to appropriate value {I don't have hardware
right now}
Just one question , will this even effect when the kernel is compiled with
no CONFIG_HIGHMEM option? Thats the image I first tried and it hung ...{When
I was expecting it to come up with 768 MB of Memory}
Thanks
Abhishek
Hi ,
Are u having a call to io_block_mapping () in ur
arch/ppc/platfrom/<board_setup.c> covering the PKMAP_BASE ( 0xfe000000) when
using a kernel configured with CONFIG_HIGHMEM ?
The io_block_mapping will be used by you to get the early serial messages on
the console.
Read the mail from Mark below
http://lists.linuxppc.org/linuxppc-embedded/200307/msg00018.html
regards
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
