Kate, Thanks for sharing your experiences with the MPC5200Lite card. Would it be possible for you to explain the steps you took to replace dbug with u-boot. Did you use dbug or a bdm? I am about to do the same thing, and fear that I might end up with a "dead" card if things go wrong : )
Kind regards, Tord Andersson -----Original Message----- From: Kate Alhola [mailto:[EMAIL PROTECTED] Sent: den 2 november 2003 20:13 To: Wolfgang Denk Cc: linuxppc-embedded at lists.linuxppc.org Subject: Re: linuxppc_2_4_mpc5200 / 5200lite zImage now working Thank you about usefull help, it looks a like doing things in newer way may be faster than do older way ;) Wolfgang Denk wrote: >No. It's much more likely that you missed to pass someother of the >required information. You have several options: manually set up a >bd_info structure with _all_ of the required information; modifying >U-Boot so that you can load and start U-Boot from RAM; installing >U-Boot into flash. > > This worked with u-boot, setting CFG_RAMBOOT made it bootting from RAM and allowed also programming u-boot to same flash as dbug so now i can start uboot from dbug and then boot linux up >You can always get a tested and working configuration by performing >the standard kernel build procedure: > > bash$ make mrproper > bash$ make icecube_5200_config > bash$ make oldconfig > bash$ make dep > bash$ make uImage > > Tanks, that was also usefull Kate -- +==================================================================+ ! Kate Marika Alhola Internet Technologies International Oy ! ! kate at iti.fi Phone +358 400 740701 Fax +358 9 8138715 ! ! kate at iki.fi http://www.iti.fi http://www.iki.fi/kate ! +==================================================================+ ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
