to see where your boot code starts:
at the BDI prompt the command:
reset halt <enter>
followed by the command
info <enter>
BDI responds with:
Target state : debug mode
Debug entry cause : debug port nonm
maskable breakpoint
Current PC : 0xfff00100
current pc is where your boot code starts
hope this helps
pat
----- Original Message -----
From: "Wolfgang Denk" <[EMAIL PROTECTED]>
Sent: Friday, December 20, 2002 1:09 PM
Subject: Re: use bdi on board with ppcbug
> In message <3E03565A.49119F4 at synergymicro.com> you wrote:
> >
> > Wouldn't it be the PowerPC reset address - 0xFFF00100?
>
> 0xFFF00100 is just one out of several possibilities, depending on CPU
> type and system configuration.
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
