> As Scott describes correctly the preferred method of booting ML300 is through > System ACE CF. System ACE CF reads ACE files and programs the FPGA and the > PowerPC processor through the JTAG chain. System ACE CF reads one of the .ace files (at most 8) from the first partition of FAT16/FAT12 fs.
> On power-up or reset System ACE CF reads the ACE file from the MicroDrive or > CompactFlash card and in a first step programs the FPGA. Then, in a second > step, from the same ACE file, it programs the processor, i.e. similar to an > external debugger it loads code and data contained in the ELF file into the > processor memories, sets the PC to the start address, and starts executing the > program. > what is this "it"? Is it System ACE CF or other small executive edited by developper? -hyding best regards ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
