Hi Shen,
Thanks for your response,
I don't know how to interprete this but it always stops with the following
status:
Target state : debug mode
Debug entry cause : machine check interrupt
Current PC : 0x00000100
Data address : 0x00000000
DSISR value : 0x00000000
Regards, Stephan
> -----Original Message-----
> From: Shen Rong [mailto:rshen at udtech.com.cn]
> Sent: Montag, 16. Juni 2003 13:03
> To: Stephan Linke
> Subject: Re: debugging using BDI2000 on MPC860
>
>
> Machine check exception vector is located at 0x200.
> 0x100 is reset vector, and it is ok.
>
> ----- Original Message -----
> From: "Stephan Linke" <Stephan.Linke at epygi.de>
> To: "Linuxppc-Embedded" <linuxppc-embedded at lists.linuxppc.org>
> Sent: Monday, June 16, 2003 6:56 PM
> Subject: debugging using BDI2000 on MPC860
>
>
> >
> > Hi,
> >
> > I want to use our BDI2000 to debug my MPC860 board. Unfortunately it always
> > stops with a machine check interrupt at 0x00000100.
> > Flashing works fine.
> > Our flash is at 0xff000000, IMMR at f0000000...
> >
> > Any ideas? How do I define the boot address in MPC860 config files.
> >
> > Thanks, Stephan
> >
> >
> >
>
>
>
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
