During boot the board comes to this point :
IDE timing: 000003e4, resetting to PIO0 timing hda: IBM-DTLA-307030, ATA DISK drive ide0 at 0xbffff8-0xbfffff,0xbffff6 on irq 14 hda: 60036480 sectors (30739 MB) w/1916KiB Cache, CHS=59560/16/63 Partition check: hda: [PTBL] [3737/255/63] hda1 hda2 < hda5 > loop: loaded (max 8 devices) Serial driver version 5.02 (2000-08-09) with MANY_PORTS SHARE_IRQ SERIAL_PCI ena bled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A eepro100.c:v1.09j-t 9/29/99 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drive rs/eepro100.html eepro100.c: $Revision: 1.36 $ 2000/11/17 Modified by Andrey V. Savochkin <saw at sa w.sw.com.sg> and others eth0: PCI device 8086:1229, 00:02:B3:60:8F:9F, IRQ 16. Board assembly 751767-004, Physical connectors present: RJ45 Primary interface chip i82555 PHY #1. Secondary interface chip i82555. Self test failed, status ffffffff: Failure to initialize the i82557. Verify that the card is a bus-master capable slot. NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP IP: routing cache hash table of 512 buckets, 4Kbytes TCP: Hash tables configured (established 2048 bind 2048) Sending BOOTP requests....<4>eth0: card reports no RX buffers. .<1>eepro100: wait_for_cmd_done timeout! .<1>eepro100: wait_for_cmd_done timeout! First off the problem seems to be that the self test fails. And then i get the wait_for_cm_done timeout! message. I have tried two different intel cards the one is i82550 based and the other is older and based on the i82559 chip. We have a Linux server here running 2.4.8 and it has the exactly same driver and it does not fail so I think it is something with the Sandpoint Reference Platform. regards Ole A. Torvmark ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
