Hi all, I have a custom router and ported the udhcp server/client on it. My router has 2 ports eth0 - LAN and eth1 - WAN. My setup is as follows: 1. To eth0: connect a stand alone windows machine
when I run the server with the command "uphcpd", it by default runs on eth0. then on the windows machine when I say "ipconfig /renew", the router assigns an IP address to the system - perfect. 2. To eth0: connect to my company network. when I run the server with the command "uphcpd", it by default runs on eth0. then when I run the client "udhcpc" the router assigns an IP address to eth0 obtained from the company server - perfect. All this happens on eth0 ONLY. I wish to configure the router as follows: To eth0: stand alone system To eth1: company network The router should get an IP from my company server and assign it to eth1 and then it should assign a IP to my standalone system connected to eth0. how do I do this? Regards Atit Shah DISCLAIMER: This email (including any attachments) is intended for the sole use of the intended recipient/s and may contain material that is CONFIDENTIAL AND PRIVATE COMPANY INFORMATION. Any review or reliance by others or copying or distribution or forwarding of any or all of the contents in this message is STRICTLY PROHIBITED. If you are not the intended recipient, please contact the sender by email and delete all copies; your cooperation in this regard is appreciated.