In message <BAY24-F40F8F31EEE582D1E998CFEAD030 at phx.gbl> you wrote: > > You know,my config file of BDI2000 is download from www.denx.de,because > there have the sbc8260's.My board run the ppcboot at first,and i can use my > BDI2000 properly with this config file.
Most probably you erased the flash (including the HRCW) and then power-cycled the board. Now your board cannot find a valid HRCW at poweron which leaves the CPU in a unusable state in which not even JTAG access is working. There should be a jumper or switch on your board to enable the default configuration - search for RSTCONF or so. Note that you may have to adjust the config file for the default configuration (BOOTADDR and maybe others, too). Best regards, Wolfgang Denk -- Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de You can observe a lot just by watchin'. - Yogi Berra
